Hi.
I need to plot Cgs vs Vgs of a NMOS transistor. I have searched a lot and followed tutorial but still in vain. Below is my circuit for simulation. My schematic and setting is attached in the picture below. Here, I chose DC analyse, with Vgs sweeping from 0 to 2V.
I created a file, namely, oppoint.scs, and wrote its content as follows:
save M2:oppoint
Then I chose Netlist and Run.
However, the error below appeared.
(please see the attached file in the second post. I can't post two images in a single post).
I couldn't figure out why. I am completely new with Cadence and I can't use SKILL.
Hope you can help.
Thanks.