Hi, I'm running a monte carlo analysis in cadence IC614 with tsmc180 tech file.
I want to evaluate the response of circuit to variation in mismatch between two rphpoly resistor and I used the rpp1opro-mis model in schematic view, then ran a typical tran simulation in ADE to be sure of true behavior of circuit. To do a MC analysis I opened a ADEXL view of circuit and ran a MC sim. But after finishing the simulation I see no variation in output transient signal for 500 different run of MC. It seems the simulator doesn't make any changes in mismatch parameters and a unique waveform is just repeated for 500 times.
the following page contains my simulation profile and setting pages...
http://obrazki.elektroda.pl/1755538300_1469629204.png
I'll be glad if anybody can help me.
Thanks in advance.