Hello everyone.
I am trying to simulate, for my undergraduate thesis, a new RF circulator that was published by Nature Physics on article called "Magnetic-free non-reciprocity and isolation based on parametrically modulated coupled-resonator loops".
My doubt is how to create a setup that understands one RF signal (sweep from 140MHz to 200Mhz) modulated by a signal with fixed frequency (15Mhz) and that has phase 120º difference between each one. After this, my goal is to plot S parameters and see the transmission from port 1 to ports 2 and 3. My curent setup use QPSS and QPSP, but the results are not good.
I have the article and I can send to you to read and understand better the problem if you wish.
Best regards.