Dear all
I am currently working on RF rectifier which has an equivalent circuit as shown in fig below.
I have calculated Zin = 355-j1797 at a frequency of 953 MHz. I want to study the transient behaviour of the above network for Pin = 1 dBm. I am using the port component in analogLib to give the input power were the source resistance should be equal to load resistance to ensure 1 dBm is transferred. This works fine if Zin is real.
However, I am not getting Pin= 1 dBm for the above complex Zin. I specify Source resistance =355 and impedance = -1797. Could any one tell me if there is a problem with my source properties. Am I specifying the complex impedance correctly? I am running transient simulation.