Hi,
I am new to the circuit design and troubleshooting. My project is to design a trans-impedance amplifier using Cadence that can amplify a signal coming from a photodiode. I started out with the regulated cascode configuration as shown in the circuit below. I look at the frequency response using AC simulation and it looks like a high pass (/net 5). The results doesn ot show any gain (transient response), or expected low-pass roll-off in the AC response.
First thing, I looked into the operating regions of the MOSFETs and adjusted the input dc voltage of the Vsin to 0.5 to make sure that the T0, T1 mosfets are in saturation(checked this with the print->dc operating points). Beyond this point, I am not sure on how to proceed and interpret the results to make changes. Any help would be greatly appreciated.
Thanks,
-Rakesh.
