Dear RF experts,
I have a few questions about EMX:
- In the EMX documents, port calibration is not mentioned anywhere. Could you tell if EMX is capable of doing this, or the calibration is already embedded inside EMX?
- When EM simulating the interconnects to transistors up to ~300GHz, we need to strip off the transistors and place 3-4 closely placed ports (either edge or internal ports) for the transistor terminals. Could EMX calibrate the ports as a group (remove the parasitics among the ports)? Is it better to use edge ports or internal ports in this case?
Thank you a lot and regards,
Anh