Quantcast
Viewing all articles
Browse latest Browse all 967

matching op capacitanances with impedance plot

Hello , I am trying to validate my output impedance plot with the OP parameters of the mosfets connected to the output.

the Cds and Cgd capacitances were shown in the zoomed plot bellow.

i have made an Idc source with AC=1V only. and plotted the imaginary part of the output node shown bellow wher Z_ac=V_ac/I_ac

imag(vfreq('ac "/net18"))  shown bellow.

However if we look at the imaginary part of the impedance and we see capacitance profile from the output Z_c=1/jwc then the plot should descend,instead it stays constant and starts to rise as if it was and inductor after 10M.

I tried to extract the capacitance from two points i notated on the plot bellow and both of them doesnt match the 10fF capacitance we should have.

Where did i go wrong matching the capacitance from the plot with the capacitane from the OP?

Thanks.

point 1:

42.1=1/(2*pi*10000*x)

3.7804×10^-7

point 2:

38.21*10^3=1/(2*pi*10000000*x)

4.16527×10^-13

Image may be NSFW.
Clik here to view.

Image may be NSFW.
Clik here to view.

Image may be NSFW.
Clik here to view.

Image may be NSFW.
Clik here to view.

Viewing all articles
Browse latest Browse all 967

Trending Articles